Lux - Related Links
Open Access Articles- Top Results for Lux
International Journal of Innovative Research in Science, Engineering and TechnologyOn The Use of Low Cost Sensors for Condition Monitoring Of Grinding Wheels
International Journal of Innovative Research in Science, Engineering and TechnologyAnalytical Solutions of Fluroscent Reporters to auxin influx in plantcells
International Journal of Innovative Research in Science, Engineering and TechnologyDetection of Defects in Ferromagnetic Materials by Nanofluid as a Sensor
International Journal of Innovative Research in Science, Engineering and TechnologyA Stator Flux Oriented Vector Control Scheme For Decoupled Control Of DFIG For Wind Energy Applications
International Journal of Innovative Research in Science, Engineering and TechnologyInnovative Electro Magnetic Braking System
The lux (symbol: lx) is the SI unit of illuminance and luminous emittance, measuring luminous flux per unit area. It is equal to one lumen per square metre. In photometry, this is used as a measure of the intensity, as perceived by the human eye, of light that hits or passes through a surface. It is analogous to the radiometric unit watts per square metre, but with the power at each wavelength weighted according to the luminosity function, a standardized model of human visual brightness perception. In English, "lux" is used in both singular and plural.
Illuminance is a measure of how much luminous flux is spread over a given area. One can think of luminous flux (measured in lumens) as a measure of the total "amount" of visible light present, and the illuminance as a measure of the intensity of illumination on a surface. A given amount of light will illuminate a surface more dimly if it is spread over a larger area, so illuminance (lux) is inversely proportional to area when the luminous flux (lumens) is held constant.
One lux is equal to one lumen per square metre:
A flux of 1000 lumens, concentrated into an area of one square metre, lights up that square metre with an illuminance of 1000 lux. However, the same 1000 lumens, spread out over ten square metres, produces a dimmer illuminance of only 100 lux.
Achieving an illuminance of 500 lux might be possible in a home kitchen with a single fluorescent light fixture with an output of 12000Lua error: Unmatched close-bracket at pattern character 67.. To light a factory floor with dozens of times the area of the kitchen would require dozens of such fixtures. Thus, lighting a larger area to the same level of lux requires a greater number of lumens.
As with other SI units, SI prefixes can be used, for example a kilolux (klx) is 1000 lux.
Here are some examples of the illuminance provided under various conditions:
|Illuminance||Surfaces illuminated by:|
|0.0001 lux||Moonless, overcast night sky (starlight)|
|0.002 lux||Moonless clear night sky with airglow|
|0.27–1.0 lux||Full moon on a clear night|
|3.4 lux||Dark limit of civil twilight under a clear sky|
|50 lux||Family living room lights (Australia, 1998)|
|80 lux||Office building hallway/toilet lighting|
|100 lux||Very dark overcast day|
|320–500 lux||Office lighting|
|400 lux||Sunrise or sunset on a clear day.|
|1000 lux||Overcast day; typical TV studio lighting|
|10000–25000Lua error: Unmatched close-bracket at pattern character 67.||Full daylight (not direct sun)|
|32000–100000Lua error: Unmatched close-bracket at pattern character 67.||Direct sunlight|
The illuminance provided by a light source, on a surface perpendicular to the direction to the source, is a measure of the strength of that source as perceived from that location. For instance, a star of apparent magnitude 0 provides 2.08 microlux at the earth's surface. A barely perceptible magnitude 6 star provides 8 nanolux. The unobscured sun provides an illumination of up to 100 kilolux on the Earth's surface, the exact value depending on time of year and atmospheric conditions. This direct normal illuminance is related to the solar illuminance constant Esc, equal to 128000Lua error: Unmatched close-bracket at pattern character 67. (see Sunlight).
The illumination provided on a surface by a point source equals the number of lux just described times the cosine of the angle between a ray coming from the source and a normal to the surface. The illumination provided by a light source that covers a large solid angle is proportional to the cosine of the angle between the surface normal and a sort of barycentre of the light source, so long as all of the source is above the plane of the surface. The number of lux falling on the surface equals this cosine times a number (in lux) that characterizes the source from the point of view in question.
The lux is also a measure of luminous emittance, the number of lumens given off by a surface per square metre, regardless of how that light is distributed in terms of the directions in which it is emitted. It differs from the luminance (measured in candela per square metre or "nits"), which does depend on the angular distribution of the emission. A perfectly white surface with one lux falling on it will emit one lux.
Relationship between illuminance and irradiance
Like all photometric units, the lux has a corresponding "radiometric" unit. The difference between any photometric unit and its corresponding radiometric unit is that radiometric units are based on physical power, with all wavelengths being weighted equally, while photometric units take into account the fact that the human eye's image-forming visual system is more sensitive to some wavelengths than others, and accordingly every wavelength is given a different weight. The weighting factor is known as the luminosity function.
The lux is one lumen per square metre (lm/m2), and the corresponding radiometric unit, which measures irradiance, is the watt per square metre (W/m2). There is no single conversion factor between lx and W/m2; there is a different conversion factor for every wavelength, and it is not possible to make a conversion unless one knows the spectral composition of the light.
The peak of the luminosity function is at 555 nm (green); the eye's image-forming visual system is more sensitive to light of this wavelength than any other. For monochromatic light of this wavelength, the amount of illuminance for a given amount of irradiance is maximum: 683.002 lux per W/m2; the irradiance needed to make one lux at this wavelength is about 1.464 mW/m2. Other wavelengths of visible light produce fewer lux per watt-per-meter-squared. The luminosity function falls to zero for wavelengths outside the visible spectrum.
For a light source with mixed wavelengths, the number of lumens per watt can be calculated by means of the luminosity function. In order to appear reasonably "white," a light source cannot consist solely of the green light to which the eye's image-forming visual photoreceptors are most sensitive, but must include a generous mixture of red and blue wavelengths to which they are much less sensitive.
This means that white (or whitish) light sources produce far fewer lumens per watt than the theoretical maximum of 683.002 lm/W. The ratio between the actual number of lumens per watt and the theoretical maximum is expressed as a percentage known as the luminous efficiency. For example, a typical incandescent light bulb has a luminous efficiency of only about 2%.
In reality, individual eyes vary slightly in their luminosity functions. However, photometric units are precisely defined and precisely measurable. They are based on an agreed-upon standard luminosity function which is based on measurements of the spectral characteristics of image-forming visual photoreception in many individual human eyes.
Use in video camera specifications
Specifications for video cameras such as camcorders and surveillance cameras often include a minimum illuminance level in lux at which the camera will record a satisfactory image. A camera with good low-light capability will have a lower lux rating. Still cameras do not use such a specification, since longer exposure times can generally be used to make pictures at very low illuminance levels, as opposed to the case in video cameras where a maximum exposure time is generally set by the frame rate.
Non-SI units of illuminance
The corresponding unit in English and American traditional units is the foot-candle. One foot candle is about 10.764 lux. Since one foot-candle is the illuminance cast on a surface by a one-candela source one foot away, a lux could be thought of as a "metre-candle", although this term is discouraged because it does not conform to SI standards for unit names.
One phot (ph) equals 10 kilolux.
One nox (nx) equals 1 millilux.
In astronomy, apparent magnitude is a measure of the illuminance of a star on the Earth's atmosphere. A star with apparent magnitude 0 is 2.54 microlux outside the earth's atmosphere, and 82% of that (2.08 microlux) under clear skies. A magnitude 6 star (just barely visible under good conditions) would be 8.3 nanolux. A standard candle (one candela) a kilometre away would provide an illuminance of 1 microlux—about the same as a magnitude 1 star.
Legacy Unicode symbol
SI photometry units
|Luminous energy||Qv [nb 2]||lumen second||lm⋅s||TJ [nb 3]||Units are sometimes called talbots.|
|Luminous flux / Luminous power||Φv [nb 2]||lumen (= cd⋅sr)||lm||J [nb 3]||Luminous energy per unit time.|
|Luminous intensity||Iv||candela (= lm/sr)||cd||J [nb 3]||Luminous power per unit solid angle.|
|Luminance||Lv||candela per square metre||cd/m2||L−2J||Luminous power per unit solid angle per unit projected source area. Units are sometimes called nits.|
|Illuminance||Ev||lux (= lm/m2)||lx||L−2J||Luminous power incident on a surface.|
|Luminous exitance / Luminous emittance||Mv||lux||lx||L−2J||Luminous power emitted from a surface.|
|Luminous exposure||Hv||lux second||lx⋅s||L−2TJ|
|Luminous energy density||ωv||lumen second per cubic metre||lm⋅s⋅m−3||L−3TJ|
|Luminous efficacy||η [nb 2]||lumen per watt||lm/W||L−2M−1T3J||Ratio of luminous flux to radiant flux.|
|Luminous efficiency / Luminous coefficient||V||1|
|See also: SI · Photometry · Radiometry|
- Standards organizations recommend that photometric quantities be denoted with a suffix "v" (for "visual") to avoid confusion with radiometric or photon quantities. For example: USA Standard Letter Symbols for Illuminating Engineering USAS Z7.1-1967, Y10.18-1967
- Alternative symbols sometimes seen: W for luminous energy, P or F for luminous flux, and ρ or K for luminous efficacy.
- "J" here is the symbol for the dimension of luminous intensity, not the symbol for the unit joules.
Notes and references
- SI Derived Units, National Institute of Standards and Technology
- NIST Guide to SI Units - 9 Rules and Style Conventions for Spelling Unit Names, National Institute of Standards and Technology
- Schlyter, Paul (1997–2009). "Radiometry and photometry in astronomy". Archived from the original on 2013-12-07.
- Bunning, Erwin; Moser, Ilse (April 1969). "Interference of moonlight with the photoperiodic measurement of time by plants, and their adaptive reaction". Proceedings of the National Academy of Sciences of the United States of America 62 (4): 1018–1022. Bibcode:1969PNAS...62.1018B. PMC 223607. PMID 16591742. doi:10.1073/pnas.62.4.1018. Retrieved 2006-11-10.
- "Electro-Optics Handbook" (PDF). photonis.com. p. 63. Retrieved 2012-04-02.
- Pears, Alan (June 1998). "Chapter 7: Appliance technologies and scope for emission reduction". Strategic Study of Household Energy and Greenhouse Issues (PDF). Sustainable Solutions Pty Ltd (Department of Industry and Science, Commonwealth of Australia). p. 61. Archived from the original (PDF) on 2 March 2011. Retrieved 2008-06-26.
- Australian Greenhouse Office (May 2005). "Chapter 5: Assessing lighting savings". Working Energy Resource and Training Kit: Lighting. Archived from the original on 2007-04-15. Retrieved 2007-03-17.
- "Low-Light Performance Calculator".
- "How to use a lux meter (Australian recommendation)" (PDF). Sustainability Victoria (sustainability.vic.gov.au). April 2010. Archived from the original (PDF) on 7 July 2011.
- "Illumination. - 1926.56". Regulations (Standards - 29 CFR). Occupational Safety and Health Administration, US Dept. of Labor. Archived from the original on 8 May 2009.
- European law UNI EN 12464
- Schlyter, Section 7
- Schlyter, Section 14.